Chapter 3 Managing Cisco SIP IP Phones
Modifying the Phone’s SIP Settings
•dtmf_inband—(Optional) Whether to detect and generate in-band signaling format. Valid values are 1 (generate DTMF digits in-band) and 0 (do not generate DTMF digits in-band). The default is 1.
•dtmf_db_level—(Optional) In-band DTMF digit tone level. Valid values are:
–1 (6 db below nominal)
–2 (3 db below nominal)
–3 (nominal)
–4 (3 db above nominal)
–5 (6 db above nominal)
The default is 3.
•dtmf_outofband—(Optional) Whether to generate the out-of-band signaling (for tone detection on the IP side of a gateway) and if so, when. The Cisco SIP IP phone supports out-of-bound signaling via the AVT tone method.
Valid values are:
–none—Do not generate DTMF digits out-of-band.
–avt—If requested by the remote side, generate DTMF digits out-of-band (and disable in-band DTMF signaling), otherwise, do not generate DTMF digits out-of-band.
–avt_always—Always generate DTMF digits out-of-band. This option disables in-band DTMF signaling.
The default is avt.
•dtmf_avt_payload—(Optional) Payload type for AVT packets. Possible range is 96 to 127. If the value specified exceeds 127, the phone will default to 101.
•timer_t1—(Optional) Lowest value (in milliseconds) of the retransmission timer for SIP messages. The valid value is any positive integer. The default is 500.
•timer_t2—(Optional) Highest value (in milliseconds) of the retransmission timer for SIP messages. The valid value is any positive integer greater than timer_t1. The default is 4000.
•timer_invite_expires—(Optional) The amount of time, in seconds, after which a SIP INVITE will expire. This value is used in the Expire header field. The valid value is any positive number, however, we recommend 180 seconds. The default is 180.
| Cisco SIP IP Phone 7960 Administrator Guide |
3-10 | 78-10497-02 |
