4
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide 9
Setting Up the Cisco SLM2008 Switch
This chapter describes how to configure the Cisco SLM2008 8-Port Gigabit Smart
Switch with PD and AC Power using the web-based configuration utility. The
following sections are included:
•Launching the Web-Based Configuration Utility, page 9
•Navigating the Utility, page10
Launching the Web-Based Configuration Utility
To configure the Cisco SLM2008 switch, follow these steps to access the web-
based configuration utility from your computer:
STEP1 Connect your computer to the same network the Cisco SLM2008 switch is
connected to.
STEP 2 Make sure your computer is on the same subnet as the switch (192.168.1.
x
).
By default, the Cisco SLM2008 switch has an IP address of 192.168.1.254 and a
default subnet mask of 255.255.255.0.
STEP 3 Launch a web browser, such as Internet Explorer or Mozilla Firefox.
STEP4 In the Address field, enter 192.168.1.254 and press Enter.
NOTE The default IP address is 192.168.1.254. If the IP address has been changed,
enter the assigned IP address instead of the default.
STEP 5 Press Enter. The web-based utility login window appears.