Advanced Configuration
Port
Cisco SLM2008 8-Port Gigabit Smart Switch with PD and AC Power Administration Guide 18
5
STEP4 Reboot the switch by going to the Admin > Reboot window. From there, click
Reboot.
Port
This section describes how to configure the port settings of the switch.
•Configuring Port Settings, page 18
•Configuring Static Link Aggregation, page 20
•Configuring LACP Settings, page 21
•Displaying LACP Status, page 23

Configuring Port Settings

You can manually configure the speed, duplex, and flow control settings used on
specific por ts, or use auto negotiation to al low the switch to au todetect the
connection settings used by the attached device. Full-duplex mode should be
used on ports whenever possible to double the throughput of switch connections.
Flow control should also be enabled to control network traffic during periods of
congestion and prevent the loss of packets when port buffer thresholds are
exceeded. The switch supports flow control based on the IEEE 802.3x standard.