Wireless-G Router for Mobile Broadband
7.Connect the power adapter to the Router’s Power port. Plug the other end into an electrical outlet. Click the Next button.
Figure 5-6: Power on the Router Screen
8.Make sure the LEDs on the Router light up. The Power LED will flash for a few seconds while the Router goes through its self-diagnostics test. This LED will be solidly lit when the self-test is complete. If it does not stop flashing, refer to “Appendix A: Troubleshooting.”
Click the Next button.
Figure 5-7: Check the Router’s Status Screen
Chapter 5: Setting up the | 21 |
Using the Setup Wizard
