Cisco Systems WRT54G3G-ST manual 7 Power on the Router Screen

Wireless-G Router for Mobile Broadband

8.Connect the power adapter to the Router’s Power port. Plug the other end into an electrical outlet. Click the Next button.

Figure 6-7: Power on the Router Screen

9.Make sure the Power, Internet, and at least one of the numbered LEDs on the Router light up. If they do not light up, make sure the cables are securely connected.

The Power LED will flash for a few seconds while the Router goes through its self-diagnostics test. This LED will be solidly lit when the self-test is complete. If it does not stop flashing, refer to “Appendix A: Troubleshooting.”

Click the Next button.

Figure 6-8: Check the Router’s Status Screen

Chapter 6: Setting up the Wireless-G Router for Broadband WAN Service Only 31

Using the Setup Wizard