Cisco Systems WRT54G3G-ST manual The Setup Tab - Basic Setup, Mobile Network Setup, Internet Setup

Wireless-G Router for Mobile Broadband

The Setup Tab - Basic Setup

The first screen that appears displays the Setup tab. This allows you to change the Router's general settings. Change these settings as described here, and click the Save Settings button to apply your changes or Cancel Changes to cancel your changes.

Mobile Network Setup

Configure the mobile network settings for the Router in this section.

Mobile Connection. This button enables you to connect to and disconnect from the mobile network through the Web-based Utility (you can also connect and disconnect using the hardware button on the Router). It will also indicate the status of the Router’s mobile broadband data card connection.

Status

Network Name. Displayed here is the name of the mobile network the Router is using.

Signal Strength. This indicates the strength of the mobile broadband signal that the Router is receiving.

Internet Setup

The Internet Setup section configures the Router to your Internet connection. Most of this information can be obtained through your ISP.

Internet Connection Type

Choose the type of Internet connection your ISP provides from the drop-down menu.

•DHCP. By default, the Router’s Internet Connection Type is set to Automatic Configuration - DHCP, which should be kept only if your ISP supports DHCP or you are connecting through a dynamic IP address.

Chapter 8: Configuring the Wireless-G Router for Mobile Broadband

Figure 8-2: Setup Tab - Basic Setup

Figure 8-3: DHCP Connection Type

54

The Setup Tab - Basic Setup