Clarity WN-5040-720 manual LEDs in Margay

LEDs in Margay

When the LED is…

LED Name	Off	Green	Amber	Red
Ready	Lamp is on (or no
	power)
Source	Source absent	Valid source present		Source absent or not
				valid
Lamp	Lamp off	Lamp on	Lamp striking	Lamp failed
Fan	Fan off	Fan is running	Fan failed recently, but	Fan failed
			is now running	Lamp disabled
Remote IR	Not receiving IR now	Receiving IR radiation
			Either door was open,
Door Open (refers to	No power to electron-	Door closed & rear	now closed	Either door open
rear panel and elec-		panel closed	Must cycle AC power
	ics			Lamp disabled
tronics module door)		Lamp enabled	to reset and enable
			lamp
Serial Data		Received any com-
		mand
	No command received
Serial Cmd		Received command
		“meant for me”
			Active
	Lamp Saver not active	Lamp Saver active	Lamp is cooling	Active
Lamp Saver		Source present	Source present	Source absent
	or lamp is off
		Lamp on	Lamp will come on	Lamp off
			when cooled
				Optical engine fault or
Optical Engine Status		Optical engine OK		communication fail-
				ure
Ballast Status 1	Lamp off	Lamp on		Ballast fault or com-
				munication failure
Ballast Supply 2				Had to wait more than
	High voltage (HV) off	HV on and ready	HV on but not ready	10 seconds for ready
				state

1.At this writing, Ballast Status LED is not implemented, so it is always off.

2.At this writing, Ballast Supply LED will show Red state only briefly.

83