Clarity WN-5040-720 Adjusting Input Levels Manually, Adjusting levels manually

3.2 Adjusting Each Margay To Its Source

3.2.1.1 Adjusting Input Levels Manually

It is rarely necessary to adjust input levels manually. You can skip this section.

Adjusting levels manually

1.Display an all-black picture from the source com- puter.

2.Press LEVEL on the remote.

3.Select MANUAL BLACK LEVEL and adjust it up and down with the +/– keys to make the three CENTER POINT values go to zero. If they do not all touch zero at the same time, use the individual colors under MANUAL BLACK LEVEL to adjust them.

Do not go beyond the point where the Minimum just goes to zero. The idea is to just touch the zero level.

4.Display an all-white picture from the source com- puter.

5.Select MANUAL WHITE LEVEL and adjust the levels until the CENTER POINT values just touch 255, adjusting the individual colors as necessary.

It is not a good idea to use the levels to make all the displays in a wall match each other. That should be done with the Color Balance menu. (“Color Balancing a Wall of Margays” on page 52.)

46