Compaq 340622-002 manual Table C-1 Selecting the Scsi ID, 3Drive Configuration Options

C-3Drive Configuration Options

Selecting the SCSI ID

Since each device on the same SCSI bus must have a unique ID, the user may need to set the drive’s ID before installation.

IMPORTANT: The drive has been configured by Compaq with SCSI ID = 6 selected. Do

not use SCSI ID = 7: this is reserved for SCSI controllers

Use the following table to obtain the appropriate jumper settings:

Table C-1

Selecting the SCSI ID

SEL2	SEL1	SEL0	SCSI ID
OPEN	OPEN	OPEN	0
OPEN	OPEN	CLOSED	1
OPEN	CLOSED	OPEN	2
OPEN	CLOSED	CLOSED	3
CLOSED	OPEN	OPEN	4
CLOSED	OPEN	CLOSED	5
CLOSED	CLOSED	OPEN	6
CLOSED	CLOSED	CLOSED	7

NOTE: In the above table, “CLOSED” indicates that a jumper has been installed.

IMPORTANT: The drive reads the jumper block settings at power-on. For changes to be effective, either the user must turn the drive OFF then back ON or the drive must receive a SCSI Bus Reset.

Compaq SLR Tape Drive User Guide