Compaq M300 Changing the Primary Battery Pack, Stopping a Calibration, Battery Pack Location

4-13

3.View the calibration reports in the Status column. The battery numbers in the Battery column correspond to the following locations:

Battery Number	Battery Pack Location
1		Computer battery bay
2		Mobile expansion unit MultiBay

4.Select any location number with “Needs calibration” beside it in the Status column.

5.Select the Start Calibration button.

Stopping a Calibration

Shut down the computer or select the Stop Calibration button on the Battery Calibration tab. The Stop Calibration button is visible only during a calibration.

Changing the Primary Battery Pack

The primary battery pack is the battery pack attached to the computer.

NOTE: For information on using a battery pack in the mobile expansion unit

MultiBay, refer to Chapter 6.

CAUTION: If the computer is on, you must initiate Hibernation or shut down power before removing or installing the battery pack. Failure to do so will result in loss of information.

WARNING: To reduce the risk of personal injury or damage to the battery pack, do not crush, puncture, or incinerate the battery pack or short the metal contacts. Do not attempt to open or service the battery pack.