Dell 200 owner manual 131, System board Screws, Connector Drive bay

1	5
2	6

3

					4
1	hard drive	2	power cable	3	serial ATA data cable
4	system board	5	screws (4)	6	screw holes in the hard
	connector				drive bay (4)

6Replace and tighten the four screws to secure the hard drive.

7Connect the power and data cables to the drive.

8Connect the data cable to the system board.

9Check all cables to be certain that they are properly connected and firmly seated.

10Replace the computer cover (see "Replacing the Computer Cover" on page 166).

NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer.

Removing and Installing Parts

131