Dell 200 owner manual Removing and Installing Parts

NOTICE: When replacing the processor, do not touch any of the pins inside the socket or allow any objects to fall on the pins in the socket.

1Follow the procedures in "Before You Begin" on page 101.

2Unpack the new processor, being careful not to touch the underside of the processor.

NOTICE: You must position the processor correctly in the socket to avoid permanent damage to the processor and the computer when you turn on the computer.

3If the release lever on the socket is not fully extended, move it to that position.

4Orient the front and rear alignment-notches on the processor with the front and rear alignment-notches on the socket.

5Align the pin-1 corners of the processor and socket.

NOTICE: To avoid damage, ensure that the processor aligns properly with the socket, and do not use excessive force when you install the processor.

6Set the processor lightly in the socket and ensure that the processor is positioned correctly.

7When the processor is fully seated in the socket, close the processor cover.

Ensure that the tab on the processor cover is positioned underneath the center cover latch on the socket.

8Pivot the socket release lever back toward the socket, and snap it into place to secure the processor.

160

Removing and Installing Parts