4Disconnect the FlexBay USB cable and the power cable from the back of the Media Card Reader and from the internal USB connector on the system board (see "System Board Components" on page 106).

5Remove the two screws securing the Media Card Reader.

6Slide the Media Card Reader out through the front of the computer.

7If you are not reinstalling the Media Card Reader, replace the drive panel insert, as needed.

8Replace the bezel (see "Replacing the Bezel" on page 125).

9Replace the computer cover (see "Replacing the Computer Cover" on page 166).

10Connect your computer and devices to electrical outlets, and then turn them on.

Installing a Media Card Reader

1Follow the procedures in "Before You Begin" on page 101.

2Remove the computer cover (see "Removing the Computer Cover" on page 103).

3Remove the bezel (see "Removing the Bezel" on page 123).

4If this is a new card reader installation:

Remove the drive panel insert (see "Removing the FlexBay Break- Away Metal Plate" on page 138).

Remove the Media Card Reader from its packaging.

5Gently slide the Media Card Reader into place in the FlexBay slot.

6Align the screw holes in the Media Card Reader with the screw holes in the FlexBay.

7Tighten the two screws to secure the Media Card Reader.

NOTE: Ensure that the Media Card Reader is installed before the FlexBay cable is connected.

8Connect the FlexBay USB cable to the back of the Media Card Reader and to the internal USB connector on the system board (see "System Board Components" on page 106).

Removing and Installing Parts

141

Page 141
Image 141
Dell 200 owner manual 141