Dell 3100C owner manual Drives, IDE Drive Addressing, Connecting Drive Cables

Models: 3100C

1 134
Download 134 pages 22.76 Kb
Page 71
Image 71

Drives

Your computer supports a combination of these devices:

One serial ATA hard drive

One FlexBay drive (floppy drive or Media Card Reader)

One CD or DVD drive

1

2

3

1

DVD drive

2

floppy drive

3

hard drive

Connect DVD drives to the connector labeled "IDE" on the system board. Serial ATA hard drives should be connected to the connectors labeled "SATA0" or "SATA1" on the system board.

IDE Drive Addressing

When you connect two IDE devices to a single IDE interface cable and configure them for the cable select setting, the device attached to the last connector on the interface cable is the master or boot device (drive 0), and the device attached to the middle connector on the interface cable is the slave device (drive 1). See the drive documentation in your upgrade kit for information on configuring devices for the cable select setting.

Connecting Drive Cables

When you install a drive, you connect two cables—a DC power cable and a data cable—to the back of the drive and to the system board.

Removing and Installing Parts

71

Page 71
Image 71
Dell 3100C owner manual Drives, IDE Drive Addressing, Connecting Drive Cables