12If you installed an
a Enter system setup, select Network Controller, and then change the setting to Off (see page 91).
b Connect the network cable to the
13Install any drivers required for the card as described in the card documentation.
Removing an Expansion Card
1Follow the procedures in "Before You Begin" on page 53.
2Gently push the release tab on the card retention door from the inside to pivot the door open. Because the door is captive, it will remain in the open position.
3If you are removing the card permanently, install a filler bracket in the empty
NOTE: Installing filler brackets over empty
4Close the card retention door by snapping it into place to secure the cards.
NOTICE: To connect a network cable, first plug the cable into the network port or device, and then plug it into the computer.
5Replace the computer cover, reconnect the computer and devices to electrical outlets, and then turn them on.
6Remove the card’s driver from the operating system.
7If you removed a sound card:
a Enter system setup, select Audio Controller, and then change the setting to On (see page 91). b Connect external audio devices to the audio connectors on the back panel of the computer.
8If you removed an
a Enter system setup, select Network Controller, and then change the setting to On (see page 91).
9Connect the network cable to the integrated connector on the back panel of the computer.
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before removing the cover.
70