w w w . d e l l . c o m s u p p o r t . d e l l . c o m

HINT: Your computer uses cable-select drive cables. This means that the device connected to the end connector of the drive cable is the master device and the device connected to the middle connector is the slave device. Be sure that the jumper setting on the new device is set for "cable select" (see the documentation that came with the drive for information).

power cable

second hard-drive cable (secondary drive)

first hard-drive cable (primary boot drive)

12Close the computer cover (see page 90).

13Connect your computer and devices to their electrical outlets, and turn them on.

NOTICE: To connect a network cable, first plug the cable in to the network wall jack and then plug it in to the computer.

14See the documentation that came with the drive for instructions on installing any software required for drive operation.

Adding Other Drives

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions listed in "When Working Inside Your Computer" on page 12.

84

Adding Parts

Page 84
Image 84
Dell 8200 manual Adding Other Drives