5Connect the two power cables to the 12V and PWR_CONN connectors on the system board. See Figure 6-2.

6Connect the chassis intrusion cable to the INTRUSION_SWITCH connector on the system board.

7Install the riser card. See "Installing the Riser Card" on page 67.

8Using a #2 Phillips screwdriver, tighten the two screws that secure the riser card to the system board.

9Install any PCI expansion cards that you removed. See "Installing an Expansion Card" on page 63.

10Connect the hard-drive interface cables:

a If you installed a SAS controller, reconnect the interface cable to the controller card.

b If your configuration uses the integrated controller, reconnect the hard drive 0 interface cable to

the SATA_0 connector and the hard drive 1 interface cable to the SATA_1 connector on the system board. See Figure 6-2 for the location of the SATA connectors.

11Install the processor and heat sink. See "Replacing the Processor" on page 71.

12Install the memory modules. See "Installing Memory Modules" on page 69.

NOTE: Install the memory modules as noted in step 3 of the procedure in "Removing the System Board Assembly" on page 75.

13Connect the control-panel interface cable to the FP_CONN1 connector on the system board. See Figure 6-2 for the location of the FP_CONN1 connector.

14If applicable, connect the optical drive interface cable to the IDE connector on the system card. See Figure 6-2 for the location of the IDE connector.

15Install the cooling shroud. See "Installing the Cooling Shroud" on page 48.

16Close the system. See "Closing the System" on page 47.

Installing System Components

77

Page 77
Image 77
Dell 860 owner manual Installing System Components