Figure 34. Replacing the NVRAM backup battery
1. positive side of battery | 2. negative side of battery connector |
Next steps
1.Install the following:
a.system board
b.IDSDM/rSPI card
c.NDC
d.PCIe mezzanine cards
e.
f.
g.cooling shroud
h.hard drives/SSDs
2.Follow the procedure listed in After working inside your system.
3.Enter the System Setup to confirm that the battery is operating properly.
4.Enter the correct time and date in the System Setup's Time and Date fields.
5.Exit the System Setup.
6.To test the newly installed battery, remove the sled for at least an hour.
7.Reinstall the sled after an hour.
8.Enter the System Setup and if the time and date are still incorrect, see Getting Help.
Related Links
Removing a hard drive/SSD
Removing the cooling shroud
Removing the
Removing the
88
