4
Installing and removing sled components
This section provides information on installing and removing the sled components. For information on installing and removing the enclosure components, see the enclosure Owner's Manual at dell.com/ poweredgemanuals.
Safety instructions
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
NOTE: It is recommended that you always use a static mat and static strap while working on components inside the system.
NOTE: To ensure proper operation and cooling, all bays in the system must be populated at all times with either a system component or with a blank.
Before working inside your system
1.Turn off the sled using the CMC.
2.Remove the sled from the enclosure.
3.Install the I/O connector cover.
After working inside your system
1.Install the sled in the enclosure.
2.Turn on the sled.
Recommended tools
You may need the following items to perform the procedures in this section:
•#1 and #2 Phillips screwdrivers
•T8 and T10 Torx drivers
•Wrist grounding strap
•Hex nut
35
