Removing a PCIe mezzanine card
Removing the Network Daughter Card
Removing the IDSDM card
Removing the rSPI card
Removing the system board
Installing the system board
Installing the IDSDM card
Installing the rSPI card
Installing the Network Daughter Card
Installing a PCIe mezzanine card
Installing the
Installing the
Installing the cooling shroud
Installing a hard drive/SSD
Removing the sled
Installing the sled
System board
Removing the system board
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: If you are using Trusted Program Module (TPM) with an encryption key, you may be prompted to create a recovery key during program or System Setup. Be sure to create and safely store this recovery key. If you replace this system board, you must supply the recovery key when you restart your system or program before you can access the encrypted data on your hard drives.
CAUTION: Do not attempt to remove the TPM
1.Ensure that you read the Safety instructions.
2.Keep the #2 Phillips screwdriver and the Hex nut
3.Follow the procedure listed in Before working inside your system.
4.Remove the following:
a.processor(s) and heat sink(s)
b.memory modules
c.cooling shroud
d.hard drive/SSDs
e.
89