Message | Causes | Corrective Actions |
|
|
|
Unsupported DIMM | Invalid memory | Ensure that the memory |
detected. The | configuration. The system | modules are installed in a valid |
following DIMM | will run but with the | configuration. See "General |
has been | specified memory module | Memory Module Installation |
disabled: x | disabled. | Guidelines" on page 86. |
|
|
|
Unsupported | Invalid memory | Ensure that the memory |
memory | configuration. Memory | modules are installed in a valid |
configuration. | modules are mismatched in | configuration. See "General |
DIMM mismatch | the specified slots. | Memory Module Installation |
across slots |
| Guidelines" on page 86. |
detected: |
|
|
x,x,... |
|
|
Warning: A fatal | A fatal system error |
error has caused | occurred and caused the |
system reset! | system to reboot. |
Please check the |
|
system event log! |
|
Check the SEL for information that was logged during the error. See the applicable troubleshooting section in "Troubleshooting Your System" on page 111 for any faulty components specified in the SEL.
Warning: | Control | The control panel is not |
Panel is | not | installed or has a faulty |
installed. | cable connection. | |
Install the control panel, or check the cable connections between the display module, the control panel board, and the system board. See "Control Panel Assembly" on page 104.
Warning! No micro Micro code update failed. | Update the BIOS firmware. |
code update | See "Getting Help" on |
loaded for | page 135. |
processor n. |
|
30
About Your System
