Dell T110 II owner manual Removing Memory Modules

Removing Memory Modules

WARNING: The memory modules are hot to touch for some time after the system has been powered down. Allow time for the memory modules to cool before handling them. Handle the memory modules by the card edges and avoid touching the components on the memory module.

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

CAUTION: To ensure proper system cooling, memory-module blanks must be installed in any memory socket that is not occupied. Install a memory-module blank if you are removing a memory module and do not intend to install a replacement.

1Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.

2Open the system. See "Opening the System" on page 59.

3Remove the expansion-card stabilizer. See "Removing the Expansion-Card Stabilizer" on page 78.

4Remove the cooling shroud. See "Removing the Cooling Shroud" on page 79.

5Locate the memory module sockets. See Figure 6-1.

CAUTION: Handle each memory module only by the card edges, ensuring not to touch the components on the module.

6Press down and out on the ejectors on each end of the socket until the memory module pops out of the socket. See Figure 3-17.

7Replace any removed memory modules with memory-module blanks to ensure proper system cooling. See "Installing Memory Modules" on page 89 for installation instructions.

8Replace the cooling shroud. See "Installing the Cooling Shroud" on page 80.

9Close the system. See "Closing the System" on page 60.

88

Installing System Components