
Option | Description |
|
|
Port D | Auto enables BIOS support for the device attached to |
(Off default) | SATA port C. Off disables BIOS support for the device. |
Port E | Auto enables BIOS support for the device attached to |
(Auto default) | SATA port C. Off disables BIOS support for the device. |
eSATA port | Auto enables BIOS support for the device attached to the |
(Auto default) | eSATA port. Off disables BIOS support for the device. |
|
|
Boot Settings Screen |
|
|
|
Option | Description |
|
|
Boot Mode | CAUTION: Switching the boot mode could prevent |
(BIOS default) | the system from booting if the operating system was |
| not installed in the same boot mode. |
| If the operating system supports Unified Extensible |
| Firmware Interface, you can set this option to UEFI. |
| Setting this field to BIOS allows compatibility with non- |
| UEFI operating systems. |
| NOTE: Setting this field to UEFI disables the Boot |
| Sequence, |
| Emulation Type fields. |
Boot Sequence Retry | If this field is enabled and the system has failed to boot, |
(Disabled default) | the system will reattempt to boot after 30 seconds. |
| |
Integrated Devices Screen | |
|
|
Option | Description |
|
|
User Accessible | Enables or disables the |
USB Ports | Options are All Ports On, Only Back Ports On, and All |
(All Ports On default) | Ports Off. |
Internal USB Port | Enables or disables the internal USB port. |
(On default) |
|
Embedded NIC1 and | Enables or disables the operating system interface of the |
NIC2 | NIC1 and NIC2 controllers. (The NICs may also be |
(Enabled default) | accessed through the system’s management controller). |
Using the System Setup Program and UEFI Boot Manager
41