Message | Causes | Corrective Actions |
Plug & | Play | Error encountered in |
Configuration | initializing PCIe device; | |
Error. |
| faulty system board. |
Install the NVRAM_CLR jumper in the clear position (pins 1 and 3) and reboot the system. See Figure
Quad rank DIMM | Invalid memory | Ensure that the memory | |
detected after | configuration. | modules are installed in a valid | |
single rank or |
| configuration. See "General | |
dual rank DIMM in |
| Memory Module Installation | |
socket. |
| Guidelines" on page 86. | |
|
|
| |
Read fault. | The operating system | Replace the optical medium, | |
Requested sector | cannot read from the hard | USB medium or device. | |
not found. | drive, optical drive, or USB | Ensure that the USB or SATA | |
device; the system could | cables are properly connected. | ||
| |||
| not find a particular sector | See "Troubleshooting a USB | |
| on the disk, or the | Device" on page 112, | |
| requested sector is | "Troubleshooting an Optical | |
| defective. | Drive" on page 121, and | |
|
| "Troubleshooting a Hard | |
|
| Drive" on page 123 for the | |
|
| appropriate drive(s) installed | |
|
| in your system. | |
|
|
| |
SATA Port x | There is no device | Information only. | |
device not found. connected to the specified |
| ||
| SATA port. |
| |
SATA port x | The drive connected to the | Replace the faulty drive. | |
device auto- | specified SATA port is |
| |
sensing error. | faulty. |
| |
SATA port x device configuration error.
SATA port x device error.
26
About Your System
