card-edge connector

notch

on drive

 

header connector

colored

on drive

strip

)LJXUH￿￿￿￿'ULYH interface

cables

colored strip

When attaching the interface cable to a drive, be sure to match the colored strip on the cable to pin 1 of the drive’s interface connector. For the location of pin 1 on the drive’s interface connector, see the documentation that came with the drive.

When disconnecting an interface cable from the system board, be sure to press in on the locking tabs on the cable connector (if any) before disconnecting the cable. When attaching an interface cable to the system board, be sure that the locking tabs snap

&into$87,21place, ￿ensuring that the cable is firmly attached to the connector on the system board.

Most interface connectors are keyed for correct insertion; that is, a notch or a missing pin on one connector matches a tab or a filled-in hole on the other connector (see Fig- ure 9-4). Keying ensures that the pin-1 wire in the cable (indicated by the colored strip along one edge of the cable) goes to the pin-1 end of the connector.

The pin- end of a connector on a board or a card is usually indicated by a silk-

WKHFRQWUROOHU5HYHUVLQJWKHFDEOHscreened￿GRQRW“1”:KHQprinted￿SODFDEOHWKHRQQGULYHdirectlyWKSUYHQWVFWLQJ￿RUORUHGonERWKDQtheWKHLQWHUIFHVWULS￿boardGULYHDorZD\IURPIURPcardFDEOH.RSHUDWLQJ￿GRSLQQRW￿RIUHYHUVHDQGWKHFRXOGFRQQHFWRUWKHGDPDJHLQWHUIDFH￿￿

9-4 Dell Precision 210 Desktop Systems User’s Guide

Page 136
Image 136
Dell WorkStation 210 manual Ljxuhulyh interface