Dell WorkStation 210 manual Icu

7DEOH&￿￿￿&RQILJXUDWLRQ0DQDJHU0HVVDJHV￿FRQWLQXHG￿
0HVVDJH	3UREDEOH&DXVH	&RUUHFWLYH$FWLRQ
WARNING: Could not	The card(s) mentioned are	If you do not know the allowable resource
configure Plug and	not fully configured due	values for your Plug and Play or PCI expansion
Play Card Name.	to resource conflicts.	card, use the following procedure to locate
WARNING: Could not		and resolve the resource conflict:
configure PCI device,		1.	Remove all card configurations from the
ID=DeviceID.			ICU.
Failed to configure			See “Removing a Card” in Chapter 4 for
Number of Total Count			instructions.
Plug and Play ISA
devices. Use your		2.	Reboot your system.
system’s configura-
tion utility to			The ICU should automatically configure
resolve conflicts.			your Plug and Play or PCI expansion card.
Press any key to
continue.		3.	Add the ISA expansion cards back into
			the ICU, resolving any resource conflicts
			as they arise.
			See “Adding a Listed Card” in Chapter 4
			for instructions.
		If your Plug and Play or PCI expansion card is
		not automatically configured when you reboot
		the system with all other cards removed, you
		should contact the manufacturer of the card
		or see the chapter titled “Getting Help” in
		your Diagnostics and Troubleshooting Guide.
WARNING: Boot Device	One of the devices is	Perform the following procedure:
conflict detected!	attempting to use one or	1.	Start the ICU.
CSN=Card Select Num-	more resources assigned
ber Error=Error.	to the system’s boot	2.	Identify the card marked config err.
	device.
			This card is attempting to use one or
			more resources required by the system’s
			boot device.
		3.	Follow the procedure for the preceding
			error message in this table.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.

C-10 Dell Precision 210 Desktop Systems User’s Guide