Dell WorkStation 210 Configuration Manager You must reconfigure the conflicting, Expansion card

7DEOH0HVVDJH&￿￿￿&RQILJXUDWLRQ8WLOLW\3UREDEOH0HVVDJHV&DXVH￿FRQWLQXHG￿		&RUUHFWLYH$FWLRQ
At least one Plug and	The Configuration Manager	You must reconfigure the conflicting
Play card in your system	or the ICU cannot configure	card(s). To find the conflicting card, per-
is not configured due to	at least one Plug and Play	form the following steps:
conflicts. These are	expansion card because of
marked “config err” in	resource conflicts with one	1.	Select the Plug and Play expansion
the list of configured	or more cards.		card marked with config err, and
cards.			then click Modify.
Due to conflicts, the ICU			The Card Configuration dialog
could only configure some			box displays the functions
Plug and Play cards in			assigned to the Plug and Play
your system. Unconfig-
			expansion card.
ured cards are marked
“config err” in the list		2.	Select a function and then click
of configured cards.
			Settings. Click the Cancel button if
			the ICU does not display a message
			naming the conflicting card.
		3.	Repeat step 2 until the ICU dis-
			plays a message box naming the
			conflicting card and the resource(s)
			in conflict. See the following table
			entry for an explanation of this
			message box.
This device is unconfig-	You cannot configure the	Perform the following procedure:
urable because of a	selected card because one	1.	Make a note of the card name and
resource conflict with	of its resources is already
card card_name. The con-	being used by another		the type of conflicting resource.
flicting resource is	device.	2.	Follow the procedure in “Modify-
resource_name. To fix,
reconfigure the			ing a Card” in Chapter 4, and
conflicting card.			change the value for
			resource_name used by
			card_name.

The ICU has successfully configured all Plug and Play cards in your system. For the new configuration to take effect, save the configu- ration, then reboot your system.

The ICU has successfully configured all of the Plug and Play expansion cards that were not configured by the Configuration Manager.

To accept these settings, save the con- figuration information into NVRAM by selecting Exit from the File menu and then selecting Yes to save. You must reboot your system for these settings to take effect.

NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary.

ISA Configuration Utility Messages C-3