Dell WorkStation 210 manual Ljxuh

)LJXUH￿￿￿￿

bracket tabs (2)

If a drive is already installed in the bay and you are replacing it, be sure to dis- connect the DC power cable and interface cable from the back of the drive before sliding the bracket out of the bay. To remove the old drive from the bracket, unscrew the four screws that secure the drive to the bracket (see Figure 9-6).

4.Attach the bracket to the new drive.

Locate the four screw holes around the drive’s perimeter. Fit the bracket over the drive, and then tilt the front of the drive up so that the bracket drops down into place. To ensure proper installation, all screw holes should be aligned and the tabs on the front of the bracket should be flush with the front of the drive (see Figure 9-6).

)LJXUHscrews￿￿￿￿(4)$WWDFKLQJ	WRbracketWKH1HZ'ULYH
	bracket tabs (2)

9-6 Dell Precision 210 Desktop Systems User’s Guide