Dell WorkStation 210 manual +Xplglw, $Owlwxgh, XVWDQG3DUWLFOHV

‡If the system has been exposed to abnormally cold temperatures, allow a two- hour warm-up period to bring it up to normal operating temperature before turning it on. Failure to do so may cause damage to internal components, particu- larly the hard-disk drive.

‡If intermittent system failures are noticed, try reseating any socketed chips, which might have become loose due to temperature fluctuations.

+XPLGLW\

High-humidity conditions can cause moisture migration and penetration into the sys- tem. This moisture can cause corrosion of internal components and degradation of properties such as electrical resistance, thermal conductivity, physical strength, and size. Extreme moisture buildup inside the system can result in electrical shorts, which can cause serious damage to the system.

Each Dell system is rated to operate at 20 to 80 percent relative humidity, with a humidity gradation of 10 percent per hour. In storage, a Dell system can withstand from 5 to 95 percent relative humidity.

Buildings in which climate is controlled by air-conditioning in the warmer months and by heat during the colder months usually maintain an acceptable level of humidity for computer equipment. However, if a system is located in an unusually humid location, a dehumidifier can be used to maintain the humidity within an acceptable range.

$OWLWXGH

Operating a system at high altitude (low pressure) reduces the efficiency of forced and convection cooling and can result in electrical problems related to arcing and corona effects. This condition can also cause sealed components with internal pres- sure, such as electrolytic capacitors, to fail or perform at reduced efficiency.

Each Dell system is rated to operate at altitudes from –16 to 3048 meters (m) (–50 to 10,000 feet [ft]) and can be stored at altitudes of –16 to 10,600 m (–50 to 35,000 ft).

'XVW￿DQG￿3DUWLFOHV

A clean operating environment can greatly reduce the negative effects of dust and other particles, which act as insulators and interfere with the operation of a system’s mechanical components. Also, in addition to regular cleaning, you should follow these guidelines to deter contamination of the system equipment:

‡

‡

‡

‡

‡

Do not permit smoking anywhere near the system.

Do not permit food or drink near the system.

Use dust covers when the system is not in use.

Keep all diskettes in a closed diskette box when not in use.

Close windows and outside doors to keep out airborne particles.

Maintaining the System D-5