Dell WorkStation 210 manual Ljxuh

To further ensure proper positioning of the drive in the chassis, insert and tighten all four screws in the order in which the holes are numbered (the holes are marked “1” through “4”).

5.Slide the new drive into the drive bay until it snaps securely into place (see Figure 9-7).

Make sure that both bracket tabs snap into place in the drive bay.

	5.25-inch drive
)LJXUH￿￿￿￿	,QWRWKH'ULYH%D\

6.If you are installing a drive that has its own controller card, install the controller card in an expansion slot.

See “Installing an Expansion Card” in Chapter 8.

7.Connect a DC power cable to the power input connector on the back of the drive (see Figure 9-8).

Installing Drives 9-7