Dell WorkStation 210 manual Dcd, Sin, Sout, Dtr, Gnd

To avoid autoconfiguration, you may be able to reset the expansion card’s jumpers or switches so that its port designation changes to the next available COM number, leav- ing the designation for the built-in port as is. Alternatively, you can disable the built-in ports through the System Setup program. The documentation for your expansion card should provide the card’s default I/O address and allowable IRQ settings. It should also provide instructions for readdressing the port and changing the IRQ setting if necessary.

The built-in parallel port has autoconfiguration capability through the System Setup program. That is, if you set the parallel port to its automatic configuration and add an expansion card containing a port configured as LPT1 (IRQ7, I/O address 378h), the system automatically remaps the built-in parallel port to its secondary address (IRQ5, I/O address 278h). If the secondary port address is already being used, the built-in parallel port is turned off. For more information, see “Parallel Port” in Chapter 3.

For general information on how your operating system handles serial and parallel ports as well as for more detailed command procedures, see your operating system

6HULDOdocumentation3RUW&RQQHFWRUV.

If you reconfigure your hardware, you may need pin number and signal information for the serial port connectors. Figure B-3 illustrates the pin numbers for the serial port connectors, and Table B-3 lists and defines the pin assignments and interface signals for the serial port connectors.

)LJXUH%￿￿￿3LQ1XPEHUVIRUWKH6HULDO3RUW&RQQHFWRUV

1 5

7DEOH&RQHFWRUV3LQ%￿￿￿6LJQDO3LQ$VVLJQPHQW,￿2 6 VIRU'HILQLWLRQWKH9 6HULDO3RUW

1	DCD	I	Data carrier detect
2	SIN	I	Serial input
3	SOUT	O	Serial output
4	DTR	O	Data terminal ready
5	GND	N/A	Signal ground

B-8 Dell Precision 210 Desktop Systems User’s Guide