Dell WorkStation 210 manual To locate the IDE1 connector, see Figure

DC power cable	power input connector
	on drive

EIDE cable

&RQV\VWHP$87,21KH￿GULYH￿<RX￿VLQWHUIDFHPXVWPDWKFRQQWKHFWORUHGRWRDYRLGVWULSSRVVLEOHRQWKH(,'(FEOHGDPDJHWRZLWK\RXUSLQ￿
IDE1
connector
IDE2
)LJXUH￿￿￿￿￿connector	interface connector

8. Connect one of the device connectors on the EIDE cable to the 40-pin interface connector on the back of the hard-disk drive (see Figure 9-12).

9. If the other end of the EIDE cable is not already connected, connect it to the IDE1

RQ&connector$87,21WKH,'(￿on￿<RXtheFRQQHFWRUWRPXVWsystemPDWFKboardDYRLGSRVVLEOHWKH. FRORUHGVWULSGDPDJHRQWKHWR\RXU(,'(FDEOHZLWKV\VWHP￿SLQ￿

To locate the IDE1 connector, see Figure 8-1.

10.Replace the computer cover. Then reconnect your computer and peripherals to their electrical outlets, and turn them on.

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

11.Insert a bootable diskette (such as the Dell Diagnostics Diskette) into drive A.

12.Enter the System Setup program, and update the appropriate Drive category (0 or 1) under Drives: Primary.

See “Drives: Primary and Secondary” in Chapter 3.

Installing Drives 9-13