Dell WorkStation 210 manual Ljxuh connector

4.Insert the expansion card into the expansion-card connector.

If the expansion card is full-length, insert the front end of the card into the corre- sponding card guide on the inside front of the chassis as you insert the card into its connector.

Insert the card’s edge connector firmly into the expansion-card slot. Gently rock the card into the connector until it is fully seated (see Figure 8-4).

expansion card

)LJXUHconnector￿￿￿￿	card-edge
	connector
expansion-card

5.When the card is firmly seated in the connector, secure the card’s mounting bracket to the chassis with the screw you removed in step 3.

6.Connect any cables that should be attached to the card.

See the documentation that came with the card for information about the card’s cable connections.

7.Replace the computer cover, and reconnect your computer and peripherals to their power sources and turn them on.

NOTE: After you remove and replace the cover, the chassis intrusion detector will cause the following message to be displayed at the next system start-up:

ALERT! Cover was previously removed.

8.To reset the chassis intrusion detector, enter the System Setup program and reset Chassis Intrusion to Not Detected.

See Chapter 3, “Using the System Setup Program,” for instructions.

NOTE: If a setup password has been assigned by someone else, contact your network administrator for information on resetting the chassis intrusion detector.

Installing System Board Options 8-5