System Board Components

 

password jumper (PASS)

hard-drive connector (PRI_IDE)

battery socket

secondary drive connector (SEC_IDE)

(BATTERY)

 

floppy-drive connector (FDD)

memory module connectors (2, 4)

power connector (PWR)

memory module connectors (1, 3)

processor and heat- sink connector (CPU_PIN_#_A1)

rear fan connector (REAR_FAN2)

rear fan connector (REAR_FAN1)

SCSI_LED header (SCSI_LED)

front-panel connector (FRONT_PANEL)

standby power light (PWR_LED)

serial ATA connector (SATA_1)

internal speaker (SPKR)

clear CMOS jumper (CMOS)

front fan (FRONT_FAN)

serial ATA connector (SATA_0)

AGP card connector (AGP)

PCI card connectors (PCI_SLOT_1, PCI_SLOT_2, PCI_SLOT_3, PCI_SLOT_4)

power connector (12V_PWR)

Memory

You can increase your computer memory by installing memory modules on the system board. For information on the type of memory supported by your computer, see "Memory" on page 105.

NOTE: DDR 333 memory operates at 320-MHz when used with an 800-MHz front-side bus processor.

Removing and Installing Parts

73

Page 73
Image 73
Dell XPS manual System Board Components, Memory