w w w . d e l l . c o m s u p p o r t . d e l l . c o m

release lever

processor

socket

6Remove the processor from the socket.

If you are replacing the processor, leave the release lever extended in the release position so that the socket is ready for the new processor and go to "Installing the Processor" on page 93.

7Replace the airflow shroud (see page 92).

8Close the computer cover (see page 102).

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

9Connect your computer and devices to electrical outlets, and turn them on.

Front Panel

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions on page 9.

Removing the Front Panel

1Follow the instructions in "Before You Begin" on page 68.

2Open the computer cover (see page 70).

3Disconnect and remove all disk drives (see "Drives" on page 81).

4Release the front panel by pressing each of the front-panel release tabs. There are seven release tabs.

96

Removing and Installing Parts

Page 96
Image 96
Dell XPS manual Removing the Front Panel, Release lever Processor Socket