Dell XPS manual Removing the Processor, retention module clip

Removing the Processor

NOTE: It is recommended that only a technically knowledgeable person perform this procedure.

CAUTION: The processor can get very hot during normal operation. Ensure that the processor has had sufficient time to cool before you touch it.

1Follow the instructions in "Before You Begin" on page 68.

2Open the computer cover (see page 70).

3Remove the processor airflow shroud (see page 91).

4Remove the processor heat sink:

a Remove the retention module clip by pressing in on the tab and lifting the retention module clip up.

b Pull the release lever out until the heat sink is released. c Lift the heat sink away from the processor.

retention module clip

retention module

heat sink processor socket

release tab

NOTICE: Lay the heat sink down with the thermal grease facing upward.

NOTICE: If you are installing a processor upgrade kit from Dell, discard the original heat sink. If you are not installing a processor upgrade kit from Dell, reuse the original heat sink when you install your new processor.

5Pull the release lever straight up until the processor is released.

NOTICE: Be careful not to bend any of the pins when you remove the processor from the socket. Bending the pins can permanently damage the processor.

Removing and Installing Parts

95