| Fault |
| Fault Descriptions |
|
| Corrective Actions |
| |
| Name |
|
|
|
| |||
|
|
|
|
|
|
|
| |
|
|
| CANopen SYNC Time out | Check if CANopen synchronous message is |
| |||
|
|
| (Only for VFDxxxExxC) | abnormal | ||||
|
|
| CANopen SDO Time out | Check if command channels are full |
| |||
|
|
| (Only for VFDxxxExxC) |
|
|
|
| |
|
|
| CANopen SDO buffer | 1. | Too short time between commands, please |
| ||
|
|
| overflow (Only for |
| check SDO message sent from the master | |||
|
|
| VFDxxxExxC) | 2. | Reset CAN bus | |||
|
|
| CAN bus off (Only for | 1. | Check if it connects to terminal resistor |
| ||
|
|
| VFDxxxExxC) | 2. | Check if the signal is abnormal | |||
3.Check if the master is connected
CAN Boot up fault (Only for | 1. | Check if the master is connected |
VFDxxxExxC) | 2. | Reset CAN bus |
Error communication protocol | Check if the communication protocol is correct | |
of CANopen (Only for |
|
|
VFDxxxExxC) |
|
|
Dimensions are in mm [inch]
Frame A
W
W1
D
D1
D2
H1 H
S1
S2
Unit: mm [inch]
| Frame | W | W1 | H | H1 | D | D1 | D2 | S1 | S2 |
| A (A1) | 72.0 | 60.0 | 142.0 | 120.0 | 152.0 | 50.0 | 4.5 | 5.2 | 5.2 |
| [2.83] | [2.36] | [5.59] | [4.72] | [5.98] | [1.97] | [0.18] | [0.20] | [0.20] | |
|
| |||||||||
| A (A2) | 72.0 | 56.0 | 155.0 | 143.0 | 111.5 | 9.5 | - | 5.3 | - |
| [2.83] | [2.20] | [6.10] | [5.63] | [4.39] | [0.37] |
| [0.21] |
| |
|
|
|
|
English- 34
