Delta Electronics VFD-XXXE quick start Explanation Settings Factory Setting, For VFD*E*C models

Pr.

Explanation

Settings

Factory Setting

NOTE

	Initial Frequency	0: by Current Freq Command
02.14	Selection (for	1: by Zero Freq Command	0
	keypad &	2: by Frequency Display at Stop
	RS485/USB)
	Initial Frequency
02.15	Setpoint (for keypad	0.00 ~ 600.0Hz	60.00
	& RS485/USB)
		Read Only
	Display the Master	Bit0=1: by First Freq Source (Pr.02.00)
		Bit1=1: by Second Freq Source (Pr.02.09)
02.16	Freq Command		##
		Bit2=1: by Multi-input function
	Source
		Bit3=1: by PLC Freq command (NOT for
		VFD*E*C models)
		Read Only
		Bit0=1: by Digital Keypad
	Display the	Bit1=1: by RS485 communication
		Bit2=1: by External Terminal 2/3 wire mode	##
02.17	Operation
		Bit3=1: by Multi-input function
	Command Source
		Bit4=1: by PLC Operation Command (NOT
		for VFD*E*C models)
		Bit5=1: by CANopen communication
	Group 3 Output Function Parameters
		0: No function	8
	Multi-function	1: AC drive operational
03.00	Output Relay (RA1,	2: Master frequency attained
	RB1, RC1)	3: Zero speed
		4: Over torque detection
		5: Base-Block (B.B.) indication	1
		6: Low-voltage indication
		7: Operation mode indication
		8: Fault indication
		9: Desired frequency 1 attained
		10: Terminal count value attained
		11: Preliminary count value attained
		12: Over Voltage Stall supervision
	Multi-function	13: Over Current Stall supervision
		14: Heat sink overheat warning
03.01	Output Terminal
		15: Over Voltage supervision
	MO1
		16: PID supervision
		17: Forward command
		18: Reverse command
		19: Zero speed output signal
		20: Warning(FbE,Cexx, AoL2, AUE, SAvE)
		21: Brake control (Desired frequency
		attained)
		22: Drive ready
		23: Desired frequency 2 attained
03.02	Desired Frequency	0.00 to 600.0Hz	0.00
	1 Attained
03.03	Analog Output	0: Analog frequency meter	0
	Signal Selection	1: Analog current meter
	(AFM)
03.04	Analog Output Gain	1 to 200%	100

English- 16