
Chapter 4
Finish setup
Use the Embedded Web Server to modify network settings
The Embedded Web Server gives you an intuitive interface to your network connection parameters.
To use the Embedded Web Server to modify network settings
1.Print a network configuration page to find the IP address for the HP Photosmart.
2.In the Address box in your Web browser on your computer, type the IP address of the HP Photosmart, as shown on the network settings page. For example, http:// 192.168.1.101.
The Embedded Web Server Information page appears, showing information for the HP Photosmart.
NOTE: If you are using a proxy server in your browser, you might need to disable it to access the Embedded Web Server.
3.Click the Networking tab.
4.Click Wired (802.3) in the navigation menu.
5.Make your changes, and then click Apply.
Related topics
“View and print network settings” on page 26
Network configuration page definitions
The network configuration page shows the network settings for the HP Photosmart. There are settings for general information, 802.3 wired (Ethernet) and Bluetooth®.
This section contains the following topics:
•General network settings
•Wired (802.3) network settings
•Bluetooth settings
Related topics
•“View and print network settings” on page 26
•“Network glossary” on page 33
30 Finish setting up the HP Photosmart