Delta Electronics VFD-XXXE quick start Explanation Settings Factory

		Pr.	Explanation	Settings	Factory	NOTE
					Setting
				0: Disabled
				1: Enabled during constant speed operation.
				After the over-torque is detected, keep
				running until OL1 or OL occurs.
			Over-Torque	2: Enabled during constant speed operation.
				After the over-torque is detected, stop
06.03			Detection Mode		0
				running.
			(OL2)
				3: Enabled during accel. After the over-
				torque is detected, keep running until OL1 or
				OL occurs.
				4: Enabled during accel. After the over-
				torque is detected, stop running.
06.04			Over-Torque	10 to 200%	150
			Detection Level
06.05			Over-Torque	0.1 to 60.0 sec	0.1
			Detection Time
			Electronic Thermal	0: Standard motor (self cooled by fan)
06.06			Overload Relay	1: Special motor (forced external cooling)	2
			Selection	2: Disabled
06.07			Electronic Thermal	30 to 600 sec	60
			Characteristic
				0: No fault
				1: Over current (oc)
			Present Fault	2: Over voltage (ov)
06.08				3: IGBT Overheat (oH1)	0
			Record
				4: Power Board Overheat (oH2)
				5: Overload (oL)
				6: Overload1 (oL1)
	06.09		Second Most	7: Motor over load (oL2)
			Recent Fault Record	8: External fault (EF)
				9: Current exceeds 2 times rated current
				during accel.(ocA)
				10: Current exceeds 2 times rated current
				during decel.(ocd)
				11: Current exceeds 2 times rated current
				during steady state operation (ocn)
				12: Ground fault (GFF)
				13: Reserved
				14: Phase-Loss (PHL)
				15: Reserved
				16: Auto Acel/Decel failure (CFA)
				17: SW/Password protection (codE)
06.10			Third Most Recent	18: Power Board CPU WRITE failure (cF1.0)
				19: Power Board CPU READ failure (cF2.0)
			Fault Record
				20: CC, OC Hardware protection failure
				(HPF1)
				21: OV Hardware protection failure (HPF2)
				22: GFF Hardware protection failure (HPF3)
				23: OC Hardware protection failure (HPF4)
				24: U-phase error (cF3.0)
				25: V-phase error (cF3.1)
				26: W-phase error (cF3.2)

English- 21