Denon POA-A1HDCI Connecting the Monitor, Connecting the Playback Components

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

NOTE

•Use a CPPM-compatible DVD player to play DVD-Audio discs that are copyright-protected by CPPM.

•The audio signals output from the HDMI connector (sampling frequency, bit rate, etc.) may be restricted by the connected device.

•Video signals are not output properly when using devices that are not HDCP-compatible.

•Video signals are not output if the input video signals do not match the monitor’s resolution. In this case, switch the DVD player’s resolution to a resolution with which the monitor is compatible.

•If the GUI menu “Manual Setup” – “HDMI Setup” – “Audio” setting (vpage 32) is set to “Amp”, the sound may be interrupted when the monitor’s power is turned off.

•Use a cable on which the HDMI logo is indicated (a certified HDMI product) for connection to the HDMI connector. Normal playback may not be possible when using a cable other than one on which the HDMI logo is indicated (a non-HDMI-certified product).

•If the monitor or DVD player does not support Deep Color, Deep Color signal transfer is not possible.

•If the monitor or DVD player does not support xvYCC, xvYCC signal transfer is not possible.

•If the monitor does not support “Auto Lipsync Correction” function, this function will not work.

•The AVP-A1HDCI is compatible with the HDMI’s CEC (Consumer Electronics Control) function. Please note the following.

•It may not work depending on the device it is connected to and its setup.

•It does not operate with televisions or players that are not compatible with HDMI’s CEC.

•When the AVP-A1HDCI and DVD player are connected using an HDMI cable, also connect the AVP-A1HDCI and monitor using an HDMI cable.

•If the connected monitor or DVD player only has a DVI-D connector, use an HDMI/DVI converter cable. When using a DVI cable, no audio signals are transmitted.

•Use a Deep Color compatible cable for connection to Deep Color compatible devices.

Connecting the Monitor

•Connect the cables to be used (vpage 9 “Video Conversion Function”).

•With HDMI connections, the video and audio signals can be transferred with a single cable.

•To output the audio signals to the monitor with HDMI connections, set GUI menu “Manual Setup” – “HDMI Setup” – “Audio” to “TV” (vpage 32).

Monitor

		7*%&0
7*%&0	4 7*%&0		$0.10/&/5 7*%&0	)%.*
*/	*/		*/	*/
			: 1# 13

NOTE

•The component video connectors may be indicated differently on your monitor. For details, see the monitor’s operating instructions.

•The audio signals output from the HDMI connectors are only the HDMI input signals.

Connecting the Playback Components

Carefully check the left (L) and right (R) channels and the inputs and outputs, and be sure to interconnect correctly.

DVD Player

•Connect the cables to be used.

•With HDMI connections, the video and audio signals can be transferred with a single cable.

DVD player

	7*%&0				"6%*0
7*%&0	4 7*%&0	$0.10/&/5 7*%&0	)%.*	$0"9*"-	"6%*0
065	065	065	065	065	065
		: 1# 13			-	3
					L	R
					L	R

•Connect an HDP (High-Definition Player) in the same way.

•When using an optical cable or a BNC cable for the digital audio connection, make the settings at GUI menu “Source Select” – “DVD”

– “Assign” – “Digital” (vpage 46).

•When using a BNC cable for the component video connection, make the settings at GUI menu “Source Select” – “DVD” – “Assign” – “Component” (vpage 47).

13