Channel Level

You can adjust the channel level either according to the playback sources or to suit your taste, as described below.

1Press CH SELECT.

2Use ui or CH SELECT to select the speaker.

The speaker that can be set switches each time one of the buttons is pressed.

Quick Select Function

With this function, the currently playing input source, input mode, surround mode, room EQ settings and volume can be stored in the memory.

1Set the input source, input mode, surround mode, room EQ settings and volume to the conditions you want to store.

2Press and hold the desired QUICK SELECT.

Keep pressing the button until the quick select indicator lights.

Last Function Memory

This stores the settings as they were directly before the standby mode was set.

When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.

Backup Memory

The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.

Setup Connections Started Getting

b ”OFF” can be set by pressing o when the subwoofer’s volume is set to –12dB.

Fader Function

This function lets you adjust (fade) the sound from all the front or rear speakers at once.

1Press CH SELECT.

2Press ui or CH SELECT to select “Fader”.

3Use o p to adjust the volume of the speakers. (o: front, p: rear)

•The fader function does not affect the subwoofer.

•The fader can be adjusted until the volume of the speaker adjusted to the lowest value is –12 dB.

[Quick Select Defaults]

 

Input Source

Volume

Quick Select 1

DVD

–40 dB

Quick Select 2

TV/CBL

–40 dB

Quick Select 3

VCR

–40 dB

•To call out the settings, press QUICK SELECT at which the desired settings were stored.

•The Quick Select name can be changed (vpage 40).

NOTE

Input sources stored with the quick select function cannot be selected if they have been deleted at GUI menu “Manual Setup” – “Option Setup” – “Source Delete” (vpage 40). In this case, store them again.

Personal Memory Plus Function

This function sets the settings (input mode, surround mode, HDMI output mode, Picture Adjust, Audio Delay etc.) last selected for the individual input sources.

When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.

The surround parameters, tone control, room EQ settings and the volumes of the different speakers are stored for the individual surround modes.

Resetting the Microprocessor

Perform this procedure if the display is abnormal or if operations cannot be performed.

All settings are reset when the microcomputer is reset.

1Turn off the power using <POWER>.

2Press <POWER> while simultaneously pressing

<STANDARD> and <HOME THX CINEMA>.

3Once the display starts flashing at intervals of about 1 second, release the two buttons.

If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.

Troubleshooting Information Zone-Multi Control Remote Playback

72