Multi-Zone Connections and Operations

Multi-Zone Connections

•For ZONE2, it is necessary to set in sequence with the signal connected to either the power amplifier or bit stream amps. The amp should be the power amplifier in the case of ZONE3, and the bit-stream for ZONE4.

•If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2 optical output connectors.

 

Connectors for audio output

Audio signals

Connectors for video output

 

 

 

 

 

ZONE2 PRE OUT

Stereo

ZONE2 VIDEO OUT,

ZONE2

 

 

ZONE2 S-VIDEO OUT,

ZONE2 OPTICAL OUT

Bit-stream

 

ZONE2 COMPONENT VIDEO OUT

 

 

 

 

ZONE3

ZONE3 PRE OUT

Stereo

ZONE3 VIDEO OUT

 

 

 

 

ZONE4

ZONE4 OPTICAL4 OUT

Bit-stream

–

 

 

 

 

Control Remote Playback Setup Connections Started Getting

MAIN ZONE (7.1-channel system)

 

 

Monitor

'- 48

 

'3

 

 

$

DVD player

AVP-A1HDCI ZONE2 video

 

 

output

Input

 

ZONE3 video

Power amplifier

 

output

 

 

 

 

Remote

 

 

control unit

4-

 

43

 

4#

4#

-3

ZONE2

Monitor

 

 

 

 

 

 

 

'- 48

 

$

'3

 

 

 

 

 

 

 

 

 

 

 

 

 

 

or

AV amplifier

 

Power amplifier

 

 

 

 

 

ZONE2 audio

 

4-

43

 

 

 

output

ZONE2 digital output

 

ZONE3

Monitor

Power amplifier

 

ZONE4

 

'-

48

'3

 

$

 

 

AV amplifier

 

4-

 

43

Troubleshooting Information Zone-Multi

ZONE3 audio output

ZONE4

 

digital output

 

 

: Video cable

 

 

: Audio cable

 

 

•When only using one speaker for ZONE2 or ZONE3, set to “Mono”. In this case, the ZONE2 (ZONE3) monaural output is output from the ZONE2 (ZONE3) pre-out L and R connectors, so connect as desired.

•Separate power amplifiers are needed for ZONE2 and ZONE3.

82