Record Player

Turntable (MM cartridge)

"6%*0

(/%

065

 

 

L R

CD Player

Connect the cables to be used.

CD player

 

 

"6%*0

 

 

9-3

"6%*0

$0"9*"-

 

065

065

065

-

3

-

3

 

 

 

L

R

 

 

 

L

R

 

iPod®

Use a DENON Control Dock for iPod (ASD-1R, sold separately) to connect the iPod to the AVP-A1HDCI. For instructions on the Control Dock for iPod settings, refer to the Control Dock for iPod’s operating instructions.

Example :

iPod

"4%3

R L

R L

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

•When connecting a record player with an MC cartridge, use a commercially available MC head amplifier or a step-up transformer.

•Induction humming (a booming sound) may be produced from the speakers if the volume is raised with no record player connected.

•With some record players, noise may be generated when the ground wire is connected. If so, disconnect the ground wire.

NOTE

The AVP-A1HDCI’s SIGNAL GND terminal is meant to reduce noise when a record player is connected. This is not a safety ground terminal.

•When using an optical cable or a BNC cable for the digital audio connection, make the settings at GUI menu “Source Select” – “CD”

– “Assign” – “Digital” (vpage 46).

•The default analog audio input setting is “RCA”. When using a balanced cable for the analog audio connection, make the settings at GUI menu “Source Select” – “CD” – “Assign” – “Analog” (vpage 47).

NOTE

The default AVP-A1HDCI balance model XLR input connectors pin alignment is as shown.

q : GROUND

w : HOT

e : COLD

•With the default settings, the iPod can be used connected to the VCR (iPod) connector.

•To assign the iPod to a connector other than VCR (iPod), make the settings at GUI menu “Source Select” – “(input source to which iPod dock assigned)” – “Assign” – “iPod dock” (vpage 47).

14