Denon POA-A1HDCI manual 25

Multi Zone

ZONE2 or ZONE3 Pre-out Connections

•If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 or ZONE3 pre-out (variable or fixed level) connectors can be used to play a different program source in ZONE2 or ZONE3 the same time (vpage 82, 83).

•To the monitor output of ZONE2, various formats of video signals input by the video conversion function are automatically converted and output (vpage 9).

•To the monitor output of ZONE3, video signals input from the S video terminal or video terminal is output (vpage 9).

•The ZONE2 (ZONE3) video out is only for ZONE2 (ZONE3).

ZONE2					ZONE3
Power		Monitor			Monitor	Power
amplifier						amplifier
"6%*0			7*%&0		7*%&0	"6%*0
"6%*0		7*%&0	4 7*%&0	$0.10/&/5 7*%&0	7*%&0	"6%*0
	*/	*/	*/	*/	*/		*/
-	3			: 1# 13		-	3
L	R					L	R
L	R					L	R

NOTE

•For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.

•For instructions on installing and operating separately sold devices, refer to the respective devices’ operating instructions.

•To conduct multi-zone playback, see “Multi-Zone Connections and Operations” (vpage 82, 83).

ZONE2 or ZONE4 Optical Connections

The AVP-A1HDCI is equipped with Optical output connectors for ZONE2 and ZONE4. If a bit-stream amp is rigged-up, these zones can also be used to enjoy home theater.

AV amplifier		AV amplifier
	(ZONE2)		(ZONE4)
	"6%*0			"6%*0
	015*$"-		015*$"-
	*/		*/

Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

					• Connect the monitor for ZONE2 the same as the “ZONE2 or ZONE3 Pre-out Connectors” (vSee left
"69	Input
065		Output			column).
Infrared			Infrared		• If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2
				Extension jack for future use.
retransmitter			sensor		optical output connectors.

22