Digi 90031300 manual Jn Constant DTE Speed Option, Kn Set Break Control

\Jn Constant DTE Speed Option

*\J0: DCE and DTE rates are independent.

\J1: DTE rate adjusts to DCE connection rate after online.

Result Codes:
OK	Returned when n = 0 or 1.
ERROR	Returned for any other value of n.

\Kn Set Break Control

Selects the way in which the modem handles a break signal. The Modem Xem can handle a break in one of three ways: expedited destructive, expedited, or queued break.

In online data mode with V.42 protocol or normal mode, then break signal to DTE through EIA-232, 0, 2, 4: Enter online command mode but do not send break to remote modem.

1: Empty the data buffers and send break to the remote modem immediately.

3: Immediately send break to the remote modem.

*5: Send break to the remote modem in sequence with data.

In online data mode with direct mode, then receive break at serial port,

0, 2, 4: Immediately send break and enter online command state.

1, 3, *5: Immediately send break through.

In online command mode with V.42 protocol or normal mode, and the DTE issues a transmit break command,

0, 1: Empty the data buffers and send break to the remote modem.

2, 3: Immediately send break to the remote modem.

4, *5: Send break to the remote modem in sequence with data.

In online data mode with normal mode, receive break signal from remote at modem port, send to serial port,

0, 1: Empty the data buffers and send break to the local DTE.

2, 3: Immediately send break to the local DTE.

4, *5: Send break to the local DTE in sequence with data.

Result Codes:
OK	Returned when n = 0, 1, 2, 3, 4 or 5.
ERROR	Returned for any other value of n.

Appendix F 113