Factory-Set Jumper J1

There is one jumper, J1, on the host adapter. This jumper is set in the factory and must not be changed.

Installing the ISA Host Adapter in your Computer

1.Turn off your computer’s power and remove the cover. Refer to your computer’s manual for instructions on cover removal and option board installation and cautions.

2.Locate an available 16-bit AT slot in your computer and remove the slot plate.

3.Plug the host adapter into the ISA slot and screw the endplate to the computer chassis.

4.Replace your computer’s cover.

5.Go to “Connecting the EPC/X Host Adapter to the T1 Modem Banks” on page 25.

22

T1 Modem Bank

Page 32
Image 32
Digi 90031300 manual Factory-Set Jumper J1, Installing the ISA Host Adapter in your Computer