Digi 90031300 manual Installing the EPC/X AIO Device Driver, Installing the AIO Application

Installing the EPC/X AIO Device Driver

See the AccelePort EPC/X device driver installation instructions in the Digi AccelePort Intelligent Serial Communications Products Novell AIO Device Driver Package Software Manual (manual part no. 92000243). This manual is included with the T1 Modem Bank package.

Installing the AIO Application

Follow the instructions in the Novell manuals to install NetWare Connect on the system to which the T1 Modem Banks are directly connected. Alternatively, you can use another AIO application like Cheyenne FaxServe or Funk Software’s Wanderlink.

Installing SNMP

SNMP is pre-installed on NetWare.

If you wish to manage the T1 Modem Banks remotely with QuickManager, you must follow these additional steps:

1.Configure the SNMP on the Novell system. This is done via the SNMP.NLM load line parameters or within INETCFG.NLM. Please see the Novell documentation for instructions.

2.Install SNMP on a Windows NT system on the network. Use the following procedure to install SNMP on the NT system:

a)Double click Control Panel.

b)Double click the Network icon.

c)When the “Network” window appears, select “Services”, then click the “Add” button.

d)Select “SNMP Service.”

Installing QuickManager

If you wish to manage the T1 Modem Banks remotely with QuickManager, you will need to install QuickManager on a Windows NT system on your network. Use the following procedure to install QuickManager:

1.Insert the T1 Modem Bank NT Setup Disk into drive A of the remote system operating under Windows NT.

2.Run A:\SETUP.EXE.

Software Installation 35