Digi 90031300 manual Sn? Read S Register n, Enable Tone dialing, Vn Result Code Format

Sn? Read S Register n

Reports the value of S register n as a 3-digit decimal number.

n=0-99

TEnable Tone dialing

Instructs the modem to use DTMF tones when dialing. Dialed digits will be tone dialed until a P command or dial modifier is received. Tone dial is the default setting.

Vn Result Code Format

Controls whether result codes are returned to the DTE.

V0: Numeric form (0 for OK).

*V1: Verbose form (OK for OK). Result Codes:

OK Returned when n = 0 or 1.

ERROR Returned for any other value of n.

Wn Select Extended Result Codes

Defines which result codes are to be used to identify the type of connection and protocol that resulted from handshaking and negotiation.

*W0:CONNECT result code reports DTE speed.

W1:CONNECT result code reports DTE speed, plus the CARRIER, COMPRESSION and PROTOCOL extended result codes.

W2:CONNECT result code reports DCE speed.

Result Codes:

OK Returned when n = 0, 1 or 2.

ERROR Returned for any other value of n.

Xn Select Result Codes/Call Progress Options

Enables the tone detection options used in the dialing process. As these functions are chosen, the modem chip set’s result codes are also affected. This command is therefore frequently used to control the modem chip set’s responses. The primary function of this control is to control the modem chip set’s call response capabilities.

X0: Display CONNECT or 1 for all speeds.

X1: Display connect message according to ATW and AT\V, blind dial, ignore busy signal.

X2: Display connect message according to ATW and AT\V, wait for dial tone, ignore busy signal.

X3: Display connect message according to ATW and AT\V, blind dial, check for busy signal after dialing.

*X4: Display connect message according to ATW and AT\V, wait for dial tone, check for busy signal after dialing.

Result Codes:

OK Returned when n = 0, 1, 2, 3 or 4.

ERROR Returned for any other value of n.

Appendix F 103