Digi 90031300 manual T1 Modem Bank

The following describes the display panel configuration/diagnostic process:

1.	Press Right	Displays current node number
2.	Press Right	Line Card T1 Line Select
3.	Press Right	goes to Diagnostic Test 1

Press Left changes node number

Press Left selects Line Interface or Drop & Insert (if no left press at Line Card T1 Line Select)

4.	Press Right	if Drop & Insert	Press Left changes EQ		0.6 1.2	1.8 2.4 3.0
5.	Press Right	goes to Diagnostic Test 1
6.	Press Right	if Line Interface	Press Left selects CSU Long Haul or DSX-1 Short Haul
7.	Press Right	if CSU Long Haul	Press Left selects AMI/D4 or B8ZS/ESF
8.	Press Right	either AMI/D4 or B8ZS/ESF	Press Left selects Jitter, EGL, LBO
9.	Press Right	goes to Diagnostic Test 1	(if no left press to select Jitter, EGL, LBO)
10.	Press Right	if Jitter	Press Left selects Rx or Tx
11.	Press Right	go to step 8 above
12.	Press Right	if EGL	Press Left selects 26 or 36
13.	Press Right	go to step 8 above
14.	Press Right	if LBO	Press Left selects	00	75 15	22
15.	Press Right	go to step 8 above

By pressing <Enter> at any time, you may exit the configuration/diagnostic mode without saving any of your changes. The POST will then resume if it had not been completed at the time you entered configuration/diagnostic mode. If POST had been completed when you entered configuration/diagnostic mode, the download will begin when you exit configuration/diagnostic mode.

To exit the configuration/diagnostic mode and save your changes, cycle the T1 Modem Bank’s power off, then on again to return to the initialized state.

46 T1 Modem Bank